4 inch Microfibre Trim Paint Roller Sleeve pack of 3

Description

The 4 inch Microfibre Trim Paint Roller Sleeve is used for cutting-in, edging and trim work on smaller areas.

Thermofused to a 1.5 inch core, it will fit our 4 inch Trim Paint Roller Frame 1.5 inch Dia. Screw Fit. It’s available in three different pile heights, extra short pile (1/4 inch), short pile (3/8 inch) and medium pile (9/16 inch). We advise you select sleeve’s with the same pile height as your main paint roller for a more consistant finish.

Our Microfibre rollers produce a super smooth finish on walls and ceilings, with little shedding, and very low splatter, holds a tonne of paint too making, improving your productivity all round!

• Extra Short Pile (1/4in / 6mm) for smooth surfaces
• Short Pile (3/8in / 10mm) for smooth to semi-smooth
• Medium Pile (9/16in / 14mm) nap for smooth to semi-rough surfaces.

• Super smooth finish.
• Shed resistant.
• Very low splatter.
• Washes out easily.
• Thermofused fabric with solvent resistant core.

Ideal for applying all low and high sheen paints and stains, Emulsions, Acrylic’s, Dead Flat Matt, and Gloss Enamels.

Use: Always pre-wet the Microfibre Paint Roller Refill Cover and spin dry before using water-borne coatings, this allows the cover to load and release paint quickly and evenly.

Cleaning: After use, immediately remove excess paint from roller with our USA sized roller scraper. Water-based coatings – wash in warm soapy water, rinse until clean, spin dry recommended using our USA sized Roller Spinner. Oil-based coatings – clean with recommened solvent according to the instructions on the outside of the paint can.

The 4 inch Microfibre Trim Paint Roller Sleeve is sold in singles, and packs of 3 rollers to save you even more.

Additional information